We repair Hunter in Parlier
Hunter parts are common on Parlier yards, and we repair them: rotor and spray heads, MP Rotators, PGV valves and solenoids, and Hunter controllers. We run each zone, find the failure, and fix it.
Everything is repaired from our Fresno location; see our national page on Hunter repair for the full list of Hunter problems we fix.
About Parlier
Parlier shares the Fresno area’s semi-arid San Joaquin Valley climate, with long, hot, dry summers, mild winters and about 11 inches of rain a year, so sprinklers carry most of the watering load.
The 2020 census counted 3,853 housing units in Parlier, and about 49.6% of occupied homes are owner-occupied. That works out to about 1,599 housing units per square mile.
The Parlier family came from Springfield, Illinois, to the site in 1876, and the city carries their name.
Wikipedia notes that Parlier has one of California’s highest percentages of Latino residents, many of them seasonal agricultural workers.
Hunter zone leaking or soggy in Parlier
A soggy strip, a geyser or a zone that went weak on a Hunter system is often a broken lateral line or fitting rather than the head. We isolate the zone, find the break and repair the pipe.
Parlier is about 19.4 miles from our Fresno location. A zone with low pressure or soggy ground usually points to a leaking line, and we trace it zone by zone.
Hunter and watering in Parlier
Parlier’s municipal code (Chapter 13.20) prohibits water waste: runoff onto a street, gutter, ditch or drain, and leaks or breaks left unrepaired. It presumes 48 hours after discovery is a reasonable time to fix a leak. We did not find assigned watering days in the code, so call City Hall at (559) 646-3545 for the current rules.
After a Hunter repair we test each zone and can set the controller to match. See the full Parlier watering schedule.
Hunter PGV valve stuck on or leaking in Parlier
A Hunter PGV valve fails like any valve: debris, a worn diaphragm or a failing solenoid. A zone that stays on, will not close or weeps at the valve box can be rebuilt or replaced, and we test the wire back to the controller.
A valve that sticks open runs a zone when the rules say it should be off (no assigned days found; the code bans runoff and unrepaired leaks), and one that will not open leaves a whole zone dry.
Hunter MP Rotator uneven or weak in Parlier
Hunter MP Rotators water slowly and evenly, so a clogged nozzle or low pressure shows up as a dry fan on the lawn. We clean or replace the nozzle, check pressure on the zone and look for a leak upstream.
In Parlier the rules in short are: no assigned days found; the code bans runoff and unrepaired leaks. A cracked or misaimed head puts water where it should not go, and a head that never rises leaves a dry patch until the next watering day.
Nearby communities
Nearby communities where we repair Hunter systems: Hunter repair in Del Rey (4.9 mi), Hunter repair in Selma (5.5 mi), Hunter repair in Sanger (6.9 mi). Distances are straight-line from the center of Parlier.
Helpful guides
- How to find a sprinkler line leak
- Leaking when the system is off?
- How to fix or replace a sprinkler valve
Written by ACRE Landscape Co., Fresno & Clovis. Updated October 26, 2026.