We repair Toro in Kerman
Toro heads and valves turn up on plenty of Kerman yards. We repair them: pop-up spray heads, rotor heads, zone valves and controllers. We run each zone first so the fix matches the failure.
Everything is repaired from our Fresno location; see our national page on Toro repair for the full list of Toro problems we fix.
About Kerman
Kerman shares the Fresno area’s semi-arid San Joaquin Valley climate, with long, hot, dry summers, mild winters and about 11 inches of rain a year, so sprinklers carry most of the watering load.
The post office was renamed Kerman in 1906.
Kerman had 16,016 residents at the 2020 census and sits at about 220 feet above sea level. Incorporated in 1946.
The 2020 census counted 4,512 housing units in Kerman, and about 58.9% of occupied homes are owner-occupied. That works out to about 1,381 housing units per square mile.
Toro zone with a leak or weak spray in Kerman
A Toro zone that went weak, or a soggy spot that never dries, often traces to a broken line or fitting, not the heads. We isolate the zone and repair the pipe.
Kerman is about 15.1 miles from our Fresno location. A zone with low pressure or soggy ground usually points to a leaking line, and we trace it zone by zone.
Toro and watering in Kerman
From March 2 through November 30, odd-numbered addresses water Tuesday, Thursday and Saturday, and even-numbered addresses Wednesday, Friday and Sunday. From December 1 through March 1, odd addresses water Tuesday and Saturday and even addresses Wednesday and Sunday. No watering on Mondays, and none between 6 and 8 a.m. or between noon and 7 p.m.
After a Toro repair we test each zone and can set the controller to match. See the full Kerman watering schedule.
Toro Super 600 or T5 head not rotating in Kerman
A Toro Super 600 or T5 that stalls, will not turn or leaks around the head often has debris in the head or a worn part. We repair or replace the head and check the pressure on the zone.
In Kerman the rules in short are: odd Tue/Thu/Sat, even Wed/Fri/Sun (Mar 2–Nov 30); two days in winter; never Mondays. A cracked or misaimed head puts water where it should not go, and a head that never rises leaves a dry patch until the next watering day.
Toro controller not running zones in Kerman
A Toro controller that will not power on or does not start a zone can be a power, wiring or valve fault. We test the zone output and repair or replace the controller.
A controller that loses its program can put you on the wrong days in Kerman (odd Tue/Thu/Sat, even Wed/Fri/Sun (Mar 2–Nov 30); two days in winter; never Mondays), so we check the schedule whenever we repair or replace one.
Nearby communities
Nearby communities where we repair Toro systems: Toro repair in Biola (5.9 mi), Toro repair in Raisin City (12.0 mi), Toro repair in Fresno (15.1 mi). Distances are straight-line from the center of Kerman.
Helpful guides
Written by ACRE Landscape Co., Fresno & Clovis. Updated October 26, 2026.